The Purifier P1 is an air purification accessory designed for the eufyMake E1 (V8260) UV Printer. It uses internal recirculation filtration to purify the gases produced during printing, with no need to vent outdoors.
¶ Package Contents
The Purifier P1 filtration and purification accessory kit includes:
Purifier (with filter)
1.5 m exhaust duct
Power adapter
Note: The air guide must be purchased separately.
After unboxing, check that all accessories are included. If anything is missing, contact customer support.
¶ Installation Steps
¶ Step 1: Install the Air Guide
Remove the cover from the printer's air filtration compartment.
Pinch the tabs with both hands and remove the original filter.
Firmly insert the air guide into place.
Note: Make sure the steel-ball locating pin on the air guide is fully inserted.
¶ Step 2: Install the Filter
Remove the purifier's cover and peel off the protective film from the cover.
Remove the filter, which is still wrapped in protective film, and take off the protective plastic bag. Insert the filter following the direction indicator on the filter. Once power is connected, the indicator light will show whether the filter is installed correctly. After confirming that the filter is properly seated, reinstall the cover.
¶ Step 3: Connect the Exhaust Duct
Connect one end of the 1.5 m exhaust duct to the air guide and the other end to the purifier.
¶ Step 4: Connect Power
Connect the power adapter and press the red power button to turn on the device.
The indicator light will enter pairing mode and remain solid blue.
¶ Step 5: Pair and Connect
After completing the physical connections, pair the Purifier P1 with the eufyMake E1 for linked control. Follow the pairing process below.
¶ Pairing Process
Open the software. Make sure the account has a printer bound to it and that you are using the primary binding account. You cannot pair the purifier if no printer is bound to the account.
Select the printer you want to connect to, tap the "+" on the device page, and then select the purifier accessory icon.
Turn on Bluetooth and search for devices, then select the corresponding purifier.
Connect to Wi-Fi, name the device, and add it to the account.
Return to the device page. When the indicator light turns off, binding is complete.